Wide fender flares wheel arches for MITSUBISHI L200 2010-2014 4-DOOR facelift

  

They are only accurate for standardized car parts. Our fender flares are custom made. Please, read carefully the description and check the photos. The best way to be sure your car is compatible with our flares is to send us a photo of your car showing the front and side. This set of arches (4 pieces) are made for the MITSUBISHI L200 DOUBLE CABIN, year 2010- 2014 (facelift model).

They extend about 8 cm from the side of the vehicle. Flares for the single and club cab (extra cab) are also available in another listing.

They are intended for the car version that comes with no original flares. If your car has the original flares and the facelift bumper, do not order these.

They will not cover the clip holes left on the bumper when the original flares are removed. They are made of good quality, hand-laid fiberglass and the surface is black gelcoat (smooth mat). Make sure your car is the model described above and shown in the photos. If you are in doubt, send me a photo of your car showing the front and side. I will reply within a day and let you know if it's the right model.

In this kind of arches, the flange of the flare does not coincide with the flange of the car wing. They only fit together on the ends of the flare. Each arch is installed by drilling and screwing 4 self tapping screws through the underside flange. The front and rear screw goes through the fiberglass, holding the ends of the flare snugly against the car wing flange, while the two in between are fitted through sheet metal strips which are fixed on the fiberglass, keeping the flare flange 2 to 3 cm lower than the car wing flange right above the wheel.

This way you don't have to put holes through the arch pockets and the sides of the vehicle, unless you want to. Another screw must go under the lower front end and the lower rear end of the flare (in total 6 screws for each arch). The clearing above the top of the flare flange allows the flare to be flushed on the inside with water so that it doesn't collect mud and debris. The arches are best installed by a professional or an experienced amateur. Installation screws, washers and rubber trim are included in the package.

Every fiberglass product is made especially for you, after your order. All shown photos are of actual cars to which our flares have been installed.

Some photos were shot in our workshop, others were kindly sent to us by customers and friends to whom we are highly obliged. The item "Wide fender flares wheel arches for MITSUBISHI L200 2010-2014 4-DOOR facelift" is in sale since Sunday, February 28, 2021. This item is in the category "Vehicle Parts & Accessories\Car Parts & Accessories\Exterior Parts & Accessories\Other Exterior Parts & Accessories". The seller is "gospoiler" and is located in Member of European Union. This item can be shipped to all countries in Europe, United States, Canada, Australia.

1. Modified Item: No
2. Custom Bundle: No
3. Surface finish: Smooth mat, black gelcoat
4. Country of origin: Cyprus (Member of European Union)
5. Non-Domestic Product: No
6. Manufacturer Part Number: TRIM1919-4DOOR
7. Material: Hand laid fiberglass
8. Also called: Strada, Sportero, Hunter
9. Brand: TRIMCO