They will not cover the holes that will be left on the sides when you remove the original plastic arches and fairings. Also, the model with the side fairings has different bumpers that are not compatible with these flares. These flares were developed on the canvas model, which doesn't have the small rounded indicators on the front sides.
If you have the saloon model, the flares will cover a small part of the indicators. You will need to trim the flare a bit where it fits over the indicator, which will still be visible on it's most part. They are made of good quality, hand-laid fiberglass and the surface is black gelcoat, lightly textured. Make sure your car is the model described above and shown in the photos.If you are in doubt, send me a few photos of your car showing the front, sides and back. I will reply within a day and let you know if its the right model. The pocket style flares were originally designed to be fitted by drilling and screwing through the flare pockets and into the side of the vehicle. But since most car owners are reluctant to drill holes on the sides of their cars, we have developed another way for installation. Each arch can be installed by drilling and screwing self tapping screws through the underside flange and sheet metal strips which are fixed on the fiberglass. The flanges of the flares touch the car wings flanges only at the ends while at the top they remain about 2 cm lower than the car wing flanges and are fixed there by sheet metal strips. To install, removing the adjacent wheel is recommended, so that you have enough space to use the drill. The help of another person is needed to hold the flare in place while the installer drills and screws. The front flares are designed so that they fit clear of the lower edge of the car wing. This was done to make sure the over-wide tires do not rub on the rear end of the flares (look at the photos). The arches are best installed by a professional or an experienced amateur. This is a difficult to install item. Dont try this yourself if you dont have enough experience.
We include the necessary screws, washers and rubber trim. Every fiberglass product is made especially for you, after your order. The procedure takes a maximum of 15business days. The item "Wide fender flares wheel arches for MITSUBISHI PAJERO (MONTERO) 2-DOOR MK2" is in sale since Friday, October 28, 2016. This item is in the category "Vehicle Parts & Accessories\Car Parts\Exterior & Body Parts\Other External/Body Parts".
The seller is "gospoiler" and is located in Member of European Union. This item can be shipped to all countries in Europe, United States, Canada, Australia.